SWR METER to Test CB Radio Antennas – Workman SWR2T

SWR Test Meter
CB Radio Frequency Range 27 MHZ
SWR 1:1 to 1:3
52 ohm impedance
SO-239 Input and Output Connectors
Heavy Duty Metal Case
Dimensions: 3 3/8 X 2 1/4 X 3 in.

Product Features

  • SWR Test Meter CB Radio Frequency Range 27 MHZ
  • SWR 1:1 to 1:3 52 ohm impedance
  • SO-239 Input and Output Connectors W/ Heavy Duty Metal Case
  • Dimensions: 3 3/8 X 2 1/4 X 3 in.

Get More Detailed Information About This Product…


Tagged , , , , , . Bookmark the permalink.

3 Responses to SWR METER to Test CB Radio Antennas – Workman SWR2T

  1. Luc S says:

    As pictured, but… I’m new to the world of CB radios, and after doing some research, I understand that I need an SWR to make sure that my antenna is of the correct length to optimize my CB’s performance. I assume (haven’t actually used it yet) that the meter will work as advertised. However, for newbies like me: note in the picture that there is no patch cable. In order to use this device, you’re going to have to find one to connect between your radio and the meter. Many of these come with the patch cable,…

  2. Jerry Swain says:

    swr meter 0

  3. Wulff says:

    Worst built SWR meter I have ever used I can’t believe the positive feedback I see on here, this unit was bent inwards on front and back (not from damage in shipping but how it was built) the needle sticks every time and you have to tap the case to get it to come down.I have been in radio since the 1960’s and have never seen anything being sold for the hobby as this.I have a 1978 Port-a-Lab 500D that I will continue to use.I would no more trust this than just guessing at your SWR!Tried to contact the seller…