RVGeek

RV & Truck Electronics best prices

The Reliance Controls PB30 NEMA 3R Power Inlet Box is an outdoor/watertight electrical inlet for a 30 Amp L14-30 generator cord. It is designed to be located outdoors where the generator is running to prevent dangerous carbon monoxide fumes from the generator from entering your house. This inlet box is then safely hardwired through an outside wall directly to the transfer switch or panel, eliminating the need for cords running through windows or doors. It is designed to be wired directly to the transfer switch or panel by using one of the four combination 1/2-inch and 3/4-inch knockouts (one on each side, bottom and back). The exclusive patented design provides generous wiring space and facilitates rough-in. The face of the box is removable for easy placement and wiring. It is constructed of steel with rugged, anti-corrosive powder-coat paint and has a spring-loaded inlet cap to prevent moisture front entering the connector inlet when not in use. Since 1909, Reliance Controls Corporation has contributed more innovations that any other single manufacturer and has been awarded over 85 patents on manual transfer switches, time switches and accessories. Reliance Controls Corporation specializes in the manufacturing of a wide variety of electrical products. The primary product line consists of heavy duty time clocks and controls, generator accessories, transfer switches and transfer panels for portable generators and inverters. And after over a century of innovation, Reliance Controls Corporation has built an enviable reputation for high quality, superior engineering and exceptional customer service.The Reliance Controls 30 Amp power inlet box is designed for outdoor use and can be hardwired directly to Reliance Controls transfer switches or panels, eliminating need for cords running through windows or doors. This rain-tight, rust-proof unit includes an NEMA L14-30P inlet plug, six knockout holes, and push-in wire connections. Using one of the four combination 1/2-inch and 3/4-inch knockouts (one on each side, bottom and back), the power inlet box can be wired directly to the transfer switch or panel. The exclusive patented design provides generous wiring space and facilitates rough-in. The face of the box is removable for easy placement and wiring. It is cUL 1008 listed and covered by a 5-year warranty.

Product Features

  • This unit is cUL listed
  • Maximum generator running watts: 8,000
  • Maximum generator input: 30A@125/250 VAC
  • Cabinet type: Outdoor, NEMA 3R
  • 5-year warranty

Click Here to Get More Detailed Information About This Product…

2 comments

  1. Ohio Guy says:

    Good Quality, Does the Job I bought this to go with my 7Kw generator and Reliance Controls 30-Amp Transfer Switch Q310C. With a 50 foot run between them I chose to run an 8/3 cable with ground. If you mount this plug against a wall or post as I did, the 3/4″ hole is blocked, leaving just the 1/2″ one which made getting the four #8 wires inside a challenge. I WAS happy that the connections to the plug accepted this size wire as well and not just 10AWG.Now when the power goes off (a frequent occurrence in my…

  2. Robert says:

    A Solid Generator Inlet Solution Summary – This is a well built generator inlet box that is easy to install and use.Background – I purchased this box to go with gas powered generator (), and a 30 AMP, 7500W generator cable (…

Comments are closed.